Unit of competency Outline

Date retreived
23/07/2026 5:16 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Set up and load in-line smart card machine

Set up and load in-line smart card machine

Unit of competency
National Code
ICPCBF406
State Code
AUP38
TGA Status
Deleted
DTWD Status
Transition (Deleted)
Current Release Number
1.00
Current Release Date
26/03/2015
View on TGA
State Implementation and Classification
Approved Date
16/09/2015
Field of Education
030103 - Printing
Original Release Date
16/09/2015
Nominal Hours
60
Description
This unit describes the performance outcomes, skills and knowledge required to set up, adjust and load an in-line smart card machine in preparation for production.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Set and adjust sections of machine
  • 1.1 All details required for the job are checked and confirmed according to job specifications
  • 1.2 Correct materials are checked and available for the job
  • 1.3 All light sensors and proximity sensors are operating
  • 1.4 Mills are set to right cavity depth for chips
  • 1.5 Tape indexer and die are cleaned and chip registration is correct
  • 1.6 Implanting module is set up and registered and adhesives are available and dispenser is clean and ready
  • 1.7 Machine and in-line components are initialised
2. Confirm computer settings
  • 2.1 Encoder settings are correct and conform to job specifications
  • 2.2 Tester settings are correct and conform to job specifications
  • 2.3 Setting on the computer that controls entire machine is correctly set
3. Set up printer unit
  • 3.1 Print head is set up and adjusted according to job specifications
  • 3.2 Ink and solvent levels are checked and refilled if necessary
  • 3.3 Settings are selected according to job specifications
  • 3.4 Drying is checked as sufficient to key ink to the substrate
  • 3.5 Printer is set up according to work health and safety (WHS) guidelines
4. Load machine
  • 4.1 Substrate is prepared according to job specifications
  • 4.2 Substrate is positioned correctly to the machine
  • 4.3 Faulty material is visually identified and removed according to WHS requirements and enterprise procedures
  • 4.4 Cards are loaded according to WHS requirements and manufacturer’s specifications and enterprise procedures
  • 4.5 Settings are checked according to job specifications before production starts
  • 4.6 Work area is safe and ready for production according to safety requirements
No information
No information
Replaces
State Code National Code Title Type
D3074 ICPCF406C Set up and load in-line smart card machine Unit of competency