Unit of competency Outline

Date retreived
23/07/2026 4:18 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install vehicle sunroofs

Install vehicle sunroofs

Unit of competency
National Code
AURVTN012
State Code
AWZ83
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030511 - Panel Beating
Original Release Date
13/07/2016
Nominal Hours
30
Description
This unit describes the performance outcomes required to position and install sunroofs in vehicles or machinery. It involves preparing for the task, selecting and using tools and equipment, developing and preparing templates, marking out and cutting roof panels, preparing cut edges, installing, sealing and finishing sunroof to manufacturer specifications, and completing workplace processes and documentation.It applies to those working in the automotive service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare to install vehicle sunroof
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Sunroof installation information is sourced and interpreted from manufacturer and original equipment manufacturer (OEM) specifications and workplace procedures
  • 1.3 Sunroof and materials are sourced and inspected for quality
  • 1.4 Hazards associated with the work are identified and risks are managed
  • 1.5 Tools and equipment are sourced and checked for serviceability
  • 1.6 Work is planned to identify suitable installation methods, minimise waste, and prevent damage to vehicle
2. Fabricate template for sunroof
  • 2.1 Suitable template materials are selected
  • 2.2 Template is fabricated according to sunroof specifications and workplace procedures
3. Mark out and cut roof panels, and prepare cut edges
  • 3.1 Accurate measurements are taken and template is used to mark out roof area to be cut
  • 3.2 Roof panels are cut and trimmed using approved methods and equipment, including vehicle protection equipment, and according to manufacturer specifications, workplace procedures, and safety and environmental requirements
  • 3.3 Cut edges are filed and prepared for sunroof installation
  • 3.4 Cut roof panel is reinforced according to OEM or approved agency’s structural requirements
  • 3.5 Marking out and cutting are completed without causing damage to vehicle or components
4. Install sunroof
  • 4.1 Sunroof is lifted into place without causing damage to vehicle or components
  • 4.2 Sunroof fit is installed and checked prior to sealing
  • 4.3 Sunroof is sealed according to manufacturer specifications
  • 4.4 Installed sunroof is checked for safe operation and is leak tested
5. Complete work processes
  • 5.1 Final inspection is made to ensure work meets workplace expectations and vehicle is presented ready for use
  • 5.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 5.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 5.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF498 AURVTN3012 Install vehicle sunroofs Unit of competency
Replaced By
State Code National Code Title Type
ODV84 AURVTN112 Install vehicle sunroofs Unit of competency