Unit of competency Outline

Date retreived
22/07/2026 10:27 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Weld polymer pipes using fusion method

Weld polymer pipes using fusion method

Unit of competency
National Code
CPCPCM3022
State Code
OCO75
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
23/12/2020
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
030711 - Boilermaking And Welding
Original Release Date
01/06/2021
Nominal Hours
8
Description
This unit specifies the skills and knowledge required to fusion weld polymer pipes. In some jurisdictions, this unit of competency may form part of accreditation, licencing, legislative, regulatory or certification requirements.
Notes
Elements and Performance Criteria
1 Prepare for work.
  • 1.1 Access, read and determine welding requirements for polymer pipes and installation methods from relevant job plans and specifications, codes, Australian standards, manufacturer’s specifications and jurisdictional requirements.
  • 1.2 Determine job priorities and sequence job tasks in consultation with others on the worksite.
  • 1.3 Identify and apply workplace policies and procedures, work health and safety (WHS) and environmental requirements.
  • 1.4 Select and check the serviceability of the appropriate tools, equipment and personal protective equipment (PPE).
2 Identify welding requirements.
  • 2.1 Create a materials list and collect materials.
  • 2.2 Check welding equipment for correct operation according to manufacturer instructions.
3 Weld and inspect pipe joints.
  • 3.1 Prepare joints using tools and techniques according to manufacturer specifications and relevant standards.
  • 3.2 Conduct test welds and verify according to job specifications.
  • 3.3 Carry out fusion welds according to relevant job plans and specifications, codes, Australian standards, manufacturer’s specifications and jurisdictional requirements.
  • 3.4 Visually inspect fusion welds for compliance with relevant job plans and specifications, codes, Australian standards, manufacturer’s specifications and jurisdictional requirements.
4 Clean up.
  • 4.1 Clear the work area, and dispose of, reuse or recycle materials in accordance with state and territory legislation and workplace policies and procedures.
  • 4.2 Clean tools and equipment, check for serviceability and report any damage, and store and secure.
No information
No information
Replaces
State Code National Code Title Type
WF845 CPCPCM3022A Weld polyethylene and polypropylene pipes using fusion method Unit of competency