Unit of competency Outline

Date retreived
23/07/2026 7:36 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Remove, refit and adjust bicycle accessories

Remove, refit and adjust bicycle accessories

Unit of competency
National Code
AURBTV001
State Code
AXE33
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030599 - Automotive Engineering And Technology, N.e.c.
Original Release Date
13/07/2016
Nominal Hours
20
Description
This unit describes the performance outcomes required to remove, refit and adjust electrical and non-electrical bicycle accessories. It involves preparing for the work, selecting and using specialist tools and equipment, inspecting, removing and replacing bicycle accessories according to fitting instructions and manufacturer specifications, and completing workplace processes and documentation. It applies to those working in the bicycle retail, service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare to remove, refit and adjust bicycle accessories
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Bicycle accessory removal and fitting instructions are interpreted and accessory specifications are checked against customer requirements
  • 1.3 Accessories are inspected for quality and compared with customer requirements
  • 1.4 Hazards associated with the work are identified and risks are managed
  • 1.5 Tools and equipment, including personal protective equipment (PPE), are selected and checked for serviceability
  • 1.6 Work area is prepared and work is planned to avoid damage to bicycle, minimise waste and use time efficiently
2. Remove accessories
  • 2.1 Accessories to be removed or repaired are identified and checked according to manufacturer specifications
  • 2.2 Accessories are removed in line with planned sequence according to workplace instructions and without causing damage to bicycle frame, other components and accessories
3. Fit, test and adjust accessories
  • 3.1 Correct positioning of new or repaired accessories is determined with regard to operational requirements, aesthetics and customer requirements
  • 3.2 Bicycle accessories are refitted according to job requirements, workplace procedures, and safety and environmental requirements
  • 3.3 Refitted accessories are tested and adjusted as required according to job requirements and customer requirements
4. Complete work processes
  • 4.1 Final inspection is made to ensure work meets workplace expectations and bicycle is presented ready for use
  • 4.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 4.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 4.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF063 AURBTV2001 Fit and adjust bicycle accessories Unit of competency
Replaced By
State Code National Code Title Type
OCI96 AURBTV101 Remove, refit and adjust bicycle accessories Unit of competency