Unit of competency Outline

Date retreived
23/07/2026 11:36 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Swage and shape saw blades

Swage and shape saw blades

Unit of competency
National Code
FWPCOT3215
State Code
AXL47
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030715 - Precision Metalworking
Original Release Date
05/10/2016
Nominal Hours
40
Description
This unit of competency describes the outcomes required to widen then press into shape, through a cold forming process, the cutting points of saw teeth to create a block that has the required hook, back, tangential and radial clearance angles for efficient saw operation. Work is completed in a wood products factory setting.The unit applies to Sawdoctor, Saw Repairer.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Set up equipment
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Identify required swage shape and thickness from existing saws and relevant records.
  • 1.3 Select appropriate personal protective and other equipment and check for operational effectiveness.
  • 1.4 Set up saw, swage and shaping equipment to meet production requirements.
  • 1.5 Check die or swage clamp or vice shape against required shape, clearances and kerf, and change as required.
  • 1.6 Secure saw in a swage clamp or vice or swager with teeth aligned to swager or vice shape.
  • 1.7 Apply anti-scuffing paste to areas of saw for swaging.
2. Swage teeth
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Complete trial swage, check and adjust swaging setup.
  • 2.3 Accept or reject trialled material and dispose of in line with environmental protection practices.
  • 2.4 Inspect swage shape and thickness and measure for tangential and radial clearance and kerf.
  • 2.5 Adjust swaging operation to meet production specifications.
  • 2.6 Check dies for wear and adjust to ensure accurate operation.
  • 2.7 Swage remaining teeth in line with production and manufacturer specifications.
3. Shape teeth
  • 3.1 File and shape excess material resulting from swaging process.
  • 3.2 Complete trial shape and check tooth tolerances, adjusting as required.
  • 3.3 Accept or reject trialled material and dispose of in line with environmental protection practices.
  • 3.4 Assess shape and check tooth alignment, adjusting remaining teeth as required.
  • 3.5 Record and report processing problems and equipment faults to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D5926 FPICOT3215B Swage and shape saw blades Unit of competency
Replaced By
State Code National Code Title Type
OBM35 FWPCOT3294 Swage and shape saw blades Unit of competency
State Code National Code Title Type
BAK8 FWP30716 Certificate III in Sawdoctoring Qualification
BAM5 FWP30316 Certificate III in Sawmilling and Processing Qualification