Unit of competency Outline

Date retreived
22/07/2026 6:44 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform general lathe operations

Perform general lathe operations

Unit of competency
National Code
FBPSUG2027
State Code
OAM28
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
18/12/2018
View on TGA
State Implementation and Classification
Approved Date
18/04/2019
Field of Education
030707 - Metal Fitting, Turning And MacHining
Original Release Date
18/04/2019
Nominal Hours
20
Description
This unit of competency describes the skills and knowledge required to carry out general lathe operations on non-CNC lathes using a three and four jaw chuck. The unit applies to individuals who work under supervision in the sugar milling industry.All work must be carried out to comply with workplace procedures according to state/territory health and safety regulations, legislation and standards that apply to the workplace.No occupational licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for lathe operations
  • 1.1 Identify machining requirements according to job specifications
  • 1.2 Select, fit and use personal protective equipment according to health and safety procedures
  • 1.3 Collect and prepare materials to be machined
  • 1.4 Set up lathe and tooling for machining operation according to workplace procedures and manufacturer’s guidelines
  • 1.5 Conduct pre-operational equipment checks according to operating procedures
  • 1.6 Identify and report health and safety hazards and maintenance requirements according to health and safety procedures
2. Operate lathe to achieve specifications
  • 2.1 Set machining parameters to meet job requirements
  • 2.2 Position materials for lathe operation according to operating procedures
  • 2.3 Start, operate and shut down the lathe according to operating procedures
  • 2.4 Check work for conformance to job specifications
  • 2.5 Identify non-conforming components, and correct as required
  • 2.6 Undertake basic routine operational maintenance according operating procedures
  • 2.7 Ensure the work area is maintained to meet work cleaning standards
No information
No information
Replaces
State Code National Code Title Type
WD857 FDFSUG227A Perform general lathe operations Unit of competency