Unit of competency Outline

Date retreived
23/07/2026 5:26 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Prepare and apply decorative surfaces for furniture

Prepare and apply decorative surfaces for furniture

Unit of competency
National Code
MSFFM3007
State Code
WI428
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
20
Description
This unit of competency covers preparing, constructing and applying veneers and inlays to furniture components.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare the work
  • 1.1 Work instructions are used to determine job requirements, including design, tolerances, process, materials, finish and quantity
  • 1.2 Construction sequence is planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Suitable work area is selected for the task
  • 1.6 Tools and equipment suitable for construction are identified and checked for safe and effective operation
2 Lay out and prepare materials
  • 2.1 Materials are selected and checked for flaws following work instructions
  • 2.2 Materials are laid out to requirements
  • 2.3 Suitable joining points are selected
  • 2.4 Material is prepared for cutting
3 Construct and apply decorative surfaces
  • 3.1 Material is cut to size and required thickness
  • 3.2 Materials are laid out in the required design
  • 3.3 Machinery is used in accordance with workplace procedures, including use of personal protective equipment
  • 3.4 Items are cut to requirements
  • 3.5 Joining process is undertaken according to workplace procedures
  • 3.6 Adhesives are applied according to workplace procedures and/or manufacturer instructions
  • 3.7 Work is checked against required quality standards
  • 3.8 Any non-conformity with the required quality standards is rectified
4 Finalise operation and maintain equipment
  • 4.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 4.2 Machinery is cleaned and left in a safe mode
  • 4.3 Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
  • 4.4 Unused hardware is collected and stored for re-use or disposal following workplace procedures
  • 4.5 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8616 LMFFM3007B Prepare and apply decorative surfaces for furniture Unit of competency
Replaced By
State Code National Code Title Type
OEK63 MSFFM3028 Prepare and apply decorative surfaces for furnishing products Unit of competency